This post is for owners of EOS 0606i AD using it with Hyperion or 3rd party 2s lipo packs for cars and charging with the HP-EOSOUT-CAR02 charge cable:
HP-EOSOUT-CAR02 2s car charging cable
When using the HP-EOSOUT-CAR02 cable the order of connection to the charger is important, in order to avoid the charger’s self-protection mode and error.
The required order of connection and disconnection:
At connection time, the end with the white 7-pin balancer plug is inserted into the charger LAST, after all other connections have been made.
At disconnection time, the white balancer plug MUST be disconnected FIRST, before any other connector.
The sequence of the remaining plugs is of no importance, except that the battery-side plugs should never be connected to the battery, if the opposite sides are not already connected to charger, to avoid short-circuit. Therefore it is best to leave the main RED-BLACK 4mm plugs connected to the charger at all times.
I have a EOS 0606i and i run a losi 14.8v 5000mah 4s 25c. My problem is the balancing plugs dont match the battery. What should i do and what can i do to use the losi battery
Comment by tyson buras — April 15, 2009 @ 20:45
Hyperion offers 4 different adapter plates to fit the balance connecters that are most used among the suppliers of battery packs. I suggest you talk to your Losi dealer to find out what type of connector is on the pack you own. Once you know that you can source the corresponding adapter plate for your charger.
Comment by go-flight — May 4, 2009 @ 20:08
Por favor,
tengo un cargador Hyperion 606I y necesito saber el esquema de la salida del balanceador. Tengo baterias LRP 2S con solo 3 conexiones para el balanceador.
Gracias
Please,
i have a EOS 0606I, I need know squema of balance connecter. I have batterys LRP 2S with only 3 conecters input balance.
Thanks
Comment by javier — June 30, 2009 @ 18:44
Hola Javier,
el esquema lo puedes ver aquí:
http://media.hyperion.hk/dn/eos/HP-EOSOUT-CAR2-Diag.gif
Comment by Eduardo — August 3, 2009 @ 10:12